Sveiki,
Norėjau paklaust dėl tokio keisto dalyko ir ar čia kaškas negėrai ar čia viskas ok ir taip turi but ? problema yra tame kad jai kietas diskas yra apkrautas pwz kopina koki faila ar pan savaime aišku apkrova yra pakilus (Higest Active Time 100%) bet čia ir yra problema kas kaskiek sek buna viena sekunde kai kietas diskas apkrautas apkrova nukrenta iki (Higest Active Time 0%) ir tada po sekundes vel toliau grysta i 100% baige kopint faila viskas ok bet ar čia taip yra normalu kad apkrovos metu pwz kopinant faila ar pan kad taip nukritineja is 100% ten viena sekunde ant 0% ir tada vel pakyla ir taip daug kartu kol baige kopint faila arba kol hardas apkrautas kaška daro čia normalu ar kaskas ne ok ? va turiu ir fotke raudonai kaikures vietas pažymėjas kur nukrenta ta momenta :
Čia taip turi but ar čia kaskas negerai kad taip daros ir kaip sutvarkyt šia problema ?
Pas mane sistema : Windows 7 Ultimate 32 Bit SP1 (Su visais updeitais)
Hardas : Seagate (313GB ATA ST9320325AS SCSI Disk Device (SATA))
Dar bšk info apie harda :
Manufacturer : Unknown manufacturer
Heads : 16
Cylinders : 16383
SATA type : SATA-II 3.0Gb/s
Device type : Fixed
ATA Standard : ATA8-ACS
LBA Size : 48-bit LBA
Power On Count : 42 times
Power On Time : 24.2 days
Speed, Expressed in Revolutions Per Minute (rpm) : 5400
Features : S.M.A.R.T., APM, NCQ
Transfer Mode : SATA II
Interface : SATA
Capacity : 313GB
Real size : 320.072.933.376 bytes
RAID Type : None
S.M.A.R.T : not supported
Hardas naujas galima sakyt katik pirktas (senas hardas (Western Digital) parejo neusibotindavo windows nebejo nei format nei ka daryt irgi wtf !? nespejau nei pratestint kas jam buvo po biski taip vis uzluzdavo kol nesupratau kad hardas ir pirkau nauja)
Nuo to laiko gaima sakyt man jau toke depresija tai čia su nauju hardu nieko ar vis dėlto kaškas ?
O gal čia kas su draivais gali but ne ?
Dar štai ka radau Event Viewer (Kas maždaug gali but susija):
"The driver detected a controller error on \Device\Harddisk1\DR4."
"The driver detected a controller error on \Device\Harddisk1\DR6."
"The driver detected a controller error on \Device\Harddisk1\DR8."
"The driver detected a controller error on \Device\Harddisk1\DR2."
"The driver detected a controller error on \Device\Harddisk2\DR2."
"The driver detected a controller error on \Device\Harddisk1\DR1."
"The driver detected a controller error on \Device\Harddisk2\DR3."
"The driver detected a controller error on \Device\Harddisk2\DR4."
"The driver detected a controller error on \Device\Harddisk2\DR5."
"The driver detected a controller error on \Device\Harddisk2\DR3."
"The driver detected a controller error on \Device\Harddisk1\DR9."
"The driver detected a controller error on \Device\Harddisk1\DR8."
"The driver detected a controller error on \Device\Harddisk1\DR6."
Ka tai reiškia ir ka reikėtu daryti ?
"Session "Circular Kernel Context Logger" failed to start with the following error: 0xC0000035"
"The speed of processor 1 in group 0 is being limited by system firmware. The processor has been in this reduced performance state for 46 seconds since the last report."
"An error was detected on device \Device\CdRom0 during a paging operation."
Dar kaška tapati meta ir su DVD Irenginiu..
"An error was detected on device \Device\Harddisk1\DR3 during a paging operation."
"An error was detected on device \Device\Harddisk1\DR4 during a paging operation."
"An error was detected on device \Device\Harddisk1\DR1 during a paging operation."
"Code integrity determined that the image hash of a file is not valid. The file could be corrupt due to unauthorized modification or the invalid hash could indicate a potential disk device error."
Iš anksto visiem ačiu už betkoke pagalba !